1. The torque developed by a 3-phase induction motor least depends on
(a) rotor current
(b) rotor power factor
(c) rotor e.m.f.
(d) shaft diameter
Ans: d
2. In an induction motor if air-gap is increased
(a) the power factor will be low
(b) windage losses will be more
(c) bearing friction will reduce
(d) copper loss will reduce In an induction motor
Ans: a
3. In induction motor, percentage slip depends on
(a) supply frequency
(b) supply voltage
(c) copper losses in motor
(d) none of the above
Ans: c
4. When R2 is the rotor resistance, X2 the rotor reactance at supply frequency
and s the slip, then the condition for maximum torque under running conditions will be
(a) sR2X2 = 1 (b) sR2 = X2
(c) R2 = sX2 id) R2 = s2X2
Ans: c
5. In case of a double cage induction motor, the inner cage has
(a) high inductance arid low resistance
(b) low inductance and high resistance
(c) low inductance and low resistance
(d) high inductance and high resis¬tance
Ans: a
6. The low power factor of induction motor is due to
(a) rotor leakage reactance
(b) stator reactance
(c) the reactive lagging magnetizing current necessary to generate the magnetic flux
(d) all of the above
Ans: d
7. Insertion of reactance in the rotor circuit
(a) reduces starting torque as well as maximum torque
(b) increases starting torque as well as maximum torque
(c) increases starting torque but maxi-mum torque remains unchanged
(d) increases starting torque but maxi-mum torque decreases
Ans: a
8. Insertion of resistance in the rotcir of an induction motor to develop a given torque
(a) decreases the rotor current
(b) increases the rotor current
(c) rotor current becomes zero
(d) rotor current rernains same
Ans: d
9. For driving high inertia loods best type of induction motor suggested is
(a) slip ring type
(b) squirrel cage type
(c) any of the above
(d) none of the above
Ans: a
10. Temperature of the stator winding of a three phase induction motor is obtained by
(a) resistance rise method
(b) thermometer method
(c) embedded temperature method
(d) all above methods
Ans: d
11. The purpose of using short-circuit gear is
(a) to short circuit the rotor at slip rings
(b) to short circuit the starting resis¬tances in the starter
(c) to short circuit the stator phase of motor to form star
(d) none of the above
Ans: a
12. In a squirrel cage motor the induced e.m.f. is
(a) dependent on the shaft loading
(b) dependent on the number of slots
(c) slip times the stand still e.m.f. induced in the rotor
(d) none of the above
Ans: c
13. Less maintenance troubles are experienced in case of
(a) slip ring induction motor
(6) squirrel cage induction motor
(c) both (a) and (b)
(d) none of the above
Ans: b
14. A squirrel cage induction motor is not selected when
(a) initial cost is the main consideration
(b) maintenance cost is to be kept low
(c) higher starting torque is the main consideration
(d) all above considerations are involved
Ans: c
15. Reduced voltage starter can be used with
(a) slip ring motor only but not with squirrel cage induction motor
(b) squirrel cage induction motor only but not with slip ring motor
(c) squirrel cage as well as slip ring induction motor
(d) none of the above
Ans: c
16. Slip ring motor is preferred over squirrel cage induction motor where
(a) high starting torque is required
(b) load torque is heavy
(c) heavy pull out torque is required
(d) all of the above
Ans: a
17. In a star-delta starter of an induction motor
(a) resistance is inserted in the stator
(b) reduced voltage is applied to the stator
(c) resistance is inserted in the rotor
(d) applied voltage per1 stator phase is 57.7% of the line voltage
Ans: d
18. The torque of an induction motor is
(a) directly proportional to slip
(b) inversely proportional to slip
(c) proportional to the square of the slip
(d) none of the above
Ans: a
19. The rotor of an induction motor runs at
(a) synchronous speed
(b) below synchronous speed
(c) above synchronous speed
(d) any of the above
Ans: b
20. The starting torque of a three phase induction motor can be increased by
(a) increasing slip
(b) increasing current
(c) both (a) and (b)
(d) none of the above
Ans: c
21. Insertion of resistance in the stator of an induction motor
(a) increases the load torque
(b) decreases the starting torque
(c) increases the starting torque
(d) none of the above
Ans: b
No comments:
Post a Comment